After selecting the proper OKM Detector as described in section Importing Scan Data from Detector, several additional options may be selected according to your detection device.
At the very beginning of the whole import process you have to select the computer interface at which your OKM Detector is connected.
As shown in figure 1, all available interfaces are listed. Please select the correct one and click "Next" to proceed.
Select Operating Mode
Selecting the right operating mode depends on your OKM Detector on one hand as well as the preferred task to fullfil on the other.
After selecting one of the operating modes you have to click "Next" or "OK", depending on your selection and OKM Detector.
Please refer to your user manual of the OKM Detector to learn about the specific details of the available operating modes!
Enter Project Information
In this step you have to enter important as well as additional scan information, that might be necessary for later analysis.
This could be anything like
Description of environment
Length and width of the scan field
Device dependent information (e.g. probe)
As seen in figure 3, you have to enter at least a proper project title as well as the length and width of your scan area before clicking "Next".
Select Soil Type
One important aspect in any scan analysis is depth measurement. Due to the fact that the correct depth depends on many soil factors, you have to select the most matching soil type to get depth indications as close as possible.
Figure 4 shows the dialog that offers you many pre-defined or individual soil types to choose from. Pick the soil type that is closest to your soil conditions before clicking "OK" to activate the data import.
Please read the corresponding user manual of your OKM Detector to initiate the data transfer of your detection device!
يشترط على جميع المواطنين في الاتحاد الأوروبي دفع ضريبة القيمة المضافة بنسبة 19% وفقا للقانون الألماني.